![]() Now, enter the following values in the two fields that appear (note: these paths could be different depending on where you installed xhprof, and how you have your Sites folder/localhost set up. For starters, if you have the Devel module installed, head over to its configuration page (at admin/config/development/devel), and check the box that says "Enable profiling of all page views and drush requests." Since I'm not leaving for DrupalCon until tomorrow, what else could I do today? There's an excellent article on Lullabot that will help you get 85% of the way towards having XHProf up and running on your Mac, working with your Drupal sites, but there are a few missing pieces and little tips that will help you get XHProf fully-armed and operational.įirst, after you've installed and configured XHProf on your Mac (and restarted MAMP/Apache so the configuration takes effect), you need to do a few things to get it working well with Drupal. The procedure is the same as found in the section installing from source except that you never run "make install." Instead you load the kexts manually, and execute the binaries directly from the source tree.I was inspired today to get XHProf working on my Mac, using MAMP PRO 2.0.5/PHP 5.3.6, after reading Reid's tweet. This method is usually appropriate only for Developers. Using without actually installing (development) If you ever want to uninstall, follow the instructions for uninstalling a source install. Sudo kextload -d spl.kext zfs.kext Uninstalling a source install # if they they still have not loaded automatically cd /System /Library /Extensions # If not, make sure kextd is aware of them sudo touch /Library /Extensions /System /Library /Extensions Sudo make install # And verify they reloaded automatically # Assuming the build completed successfully, # unload the kexts. Additionally, as of XCode 8, if you are on 10.11 specifically (unnecessary on 10.12), you need to install the CLT (Command Line Tools): ![]() Note: Xcode 6.3 or later is now required to build due to Broadwell CPU support requirements. Similarly, if you have installed the O3X installer version, please follow the uninstallation directions before proceeding. If you have any other implementation of ZFS installed, you must uninstall it and reboot before proceeding further. Starting with macOS Catalina, you will probably also want to disable the reboot to load kext using: The -without option takes a comma-delimited list or can be specified multiple times: -without kext,debug,dtrace is equivalent to -without kext -without debug -without dtrace). If you specify all of them, that is equivalent to csrutil disable. (Depending on your needs, other options you may want are -without fs, -without debug, -without dtrace, or -without nvram. The latter will allow you to load your custom-built, unsigned kernel extensions, while keeping the rest of System Integrity Protection (SIP) in place. configure CPPFLAGS="-I/usr/local/opt/gettext/include LDFLAGS="-L/usr/local/opt/gettext/lib/ CFLAGS="-g -O0" -sysconfdir=/etc -localstatedir=/var -prefix=/usr/local -sbindir=/usr/local/binīefore doing anything else, please set your boot-args. ![]() Installing from source Initial installation from source ![]() If you ever want to uninstall, follow the instructions for uninstalling a release version. Start the installer by opening OpenZFS_on_OS_X_x.y.z.pkg.īash completion is also available: see Bash_completion page 4 Migrating old pools (from MacZFS or ZEVO)ĭownload the most recent dmg from the Downloads page.3 Using without actually installing (development).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |